Main > Main Forum

Trackball Molex Connector

(1/1)

brock.sampson:
I'm building a spinner out of a happ trackball encoder board.  I cannot find the part number for the four pin molex connector that goes to the board.  I checked my local Radio Shack and struck out.  Does anybody know this part number?

Thanks,
Brad

ahofle:
I doubt you'll find what you're looking for at radio sack unless it's a cell phone.  Have you tried looking online?
Something like this:
http://www.action-electronics.com/molex.htm

shardian:
Since it is permanent you can always just solder the connections. No need in adding cost to a cheep spinner. ;D

ChadTower:

Or, to compromise, use quick disconnects, and label the wire pairs.

Navigation

[0] Message Index

Go to full version