Main > Main Forum

RAM Controls - Star Wars Yoke

<< < (12/27) > >>

NoOne=NBA=:
The main failure was usually the thumb button assemblies.
They aren't quite up to the standard of the rest of the parts.
Fortunately they were redundant on most of the games, so when one quit you could still play.

The second most fragile part is probably the small gear on the back.

The most annoying failure is the rubber they used for the axis stops.
It turns to a nearly impossible to remove sludge that just smears around as you try to clean it off.
My one other annoyance with them is that it is almost impossible to get a balanced set of torsion springs for them.
If you look at almost every one you ever see, it will be sitting off-center because the springs aren't balanced.

Chunce DeLeone:
Just Wanted to see if anyone has an update on the Yoke.

David Are You out there???

MameMaster!:
any update?  ???

Chunce DeLeone:
Short Update:  David has recieved the powder coating equip and is doing it inhouse, he will update the website soon. 

Level42:
 :blah: :blah: :blah:

Actions speak louder than words.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version