Main > Main Forum

How do I assign buttons to my Ultimarc 360?

<< < (2/2)

javeryh:

--- Quote from: Havok on April 18, 2007, 11:00:12 am ---
--- Quote from: javeryh on April 18, 2007, 09:37:03 am ---Thanks - I was hoping there was some magical solution.  Do I have to assign the buttons for every single game?  What a pain! 

--- End quote ---

After hitting [Tab], select Input general, and it will set your assignments for all games...

--- End quote ---

Hmmm... I thought I tried that out last night and the settings didn't keep from one game to the next.  I'll give it another shot because that makes the most sense...

rockin_rick:
Maybe you could just redo the U360 maps.  Then it would send a UP when it's actually being read as DOWN (while you are pushing up).

I'd think that the 'input general' would be just as easy.

Is there a reason you don't want to rotate the PCB to the correct orientation?  I'm guessing - wire routing?

Rick

javeryh:

--- Quote from: rockin_rick on April 18, 2007, 05:19:57 pm ---Maybe you could just redo the U360 maps.  Then it would send a UP when it's actually being read as DOWN (while you are pushing up).

I'd think that the 'input general' would be just as easy.

Is there a reason you don't want to rotate the PCB to the correct orientation?  I'm guessing - wire routing?

Rick


--- End quote ---

Nah, I'm going to flip the U360 the right way.  Everything is wired and I thought it would be a problem but then I remembered that I'm an idiot and the harness and USB cable are easliy unpluggable.  It shouldn't be a problem.  Now all I have to do is figure out how to configure the buttons.

rockin_rick:
It may work fine as is (with proper config - I don't know I haven't gotten that far yet...), but if not, then maybe joy2key?

Rick

Navigation

[0] Message Index

[*] Previous page

Go to full version