Main > Main Forum
2 Questions with pictures
(1/1)
urbecrisch:
I'll get right to the nitty gritty.
1. What is this (PIC 1) and is it important to use?
2. How would I make this angle cut (PIC 2) on my CP?
Cheers!
destructor:
1. Door switch. If door is open no power to PCB, or power is for test game mode. You can remove this and connect wires from this switch.
NoOne=NBA=:
--- Quote from: urbecrisch on April 15, 2007, 11:54:04 pm ---2. How would I make this angle cut (PIC 2) on my CP?
--- End quote ---
With the board stood on end on a table saw.
Set the rip fence 1/2" or so off the blade, and put the blade at the right angle.
You'll probably need to remove the blade guard to do it, so be careful.
Alternately, you could use a belt sander to do it.
Navigation
[0] Message Index
Go to full version