Main > Main Forum

U360 Newbie Question

(1/2) > >>

TexFlood:
Ok, so I may be missing something obvious here.  I've received my U360 control and I ordered the stiff spring and longer handle.  So I'm trying to install these add-ons.  I've successfully unscrewed the 4 screws from the top mount and removed the handle.  I can take off the magnet at the bottom, but now according to the Ultimarc website I need to:

Lift off the magnet assembly from the end of the shaft. Remove the E-Ring. CARE: we advise to avoid spring-loaded parts being lost, place a cloth over the joystick when removing the E-ring. Swap the shafts and/or springs over and re-assemble.

I believe the E-Ring is the small piece of metal at the bottom of the handle that is sitting in the little handle groove.  I've been trying to gently remove this piece but it doesn't seem to be an easy thing.  I'm going to ask this before I break the thing, how do you remove the E-Ring easily?
 :dunno

destructor:
Search this forum for E-Ring.

I use tiny screwdriver.

Aurich:
You don't, e-rings suck.  :banghead:

Don't be afraid to use a little force, jam a slot head screwdriver in there and twist.

javeryh:
I remember having a hard time getting the e-ring off too - a little force is OK.  When I finally got it off I was worried about putting it back together but that part was easy.

Hoopz:
Using small screwdriver is good.  I also use needle nose pliers to keep hold of it.

And they are easily replaceable if you do lose one. I bought extras at Lowes before and keep them on hand just in case....

Navigation

[0] Message Index

[#] Next page

Go to full version