Main > Main Forum

trackball mount confusion

(1/2) > >>

rockin_rick:
I want to get a highlip trackball.  This is the one, right?

http://www.happcontrols.com/trackballs/56010011.htm

Is this the mount that goes with it?

http://www.happcontrols.com/trackballs/55032100.htm

It seems as if this is the best mount, at the best (lowest) price.  BUT I've read threads that say the larger mount (this one?) is the expensive one and that the highlip uses the normal mount.  So this info seems contradictory and I've also seen threads that say other trackball info on Happ's site is wrong...

In this instance, does Happ have the wrong info?  Is this correct?

Thanks,
Rick

bleargh:
I had the same question and actually phoned Happ a few weeks back about it...

The answer I was given was that the 3" high-lip trackball should fit in any of the 3" kits that they have, except for the kit made for the high-ball.  While on the phone I asked about the parts on the following page, and was told that either "55-1101-00", "55-1102-00", or "55-0321-00" (the one you're referring to) would fit a 3" or 3" high-lip trackball:
    http://www.happ.com/trackballs/55110100.htm

According to the guy I spoke with on the phone, the "high-ball" mounts the ball higher and so it requires a wider hole to put the ball through.  As for all of the other 3" kits, he said that they'll all fit a 3" high-lip ball.

I hope he's right too... I'm about to order the "55-1102-00" mounting kit myself...

Can anyone else confirm this as being correct or just crap?

u_rebelscum:
Confirm. 

The highlip aka GT, and the normal TBs fit the 55-1101-00, 55-1102-00, & 55-0321-00 kits, and 56-5530-00 plate.  I have the first two kits.  I'm guess the last kit is the cheapest due to volume and/or supply & demand, even though it's probably better (but I don't have one to compare).

The highball needs a bigger center hole (3.25" vs 3"), and thus need either 55-1103-00 or 55-1104-00 kits.  I have the latter and sure enough, it has a bigger hole that fits the highball TB great, but is too big for the normal TBs.  ;)  (Actually, if you don't mind a 1/8" gap all the way around your normal or highlip it will "work". ::))

rockin_rick:
Thanks for the info guys.

Rick

bleargh:
BTW.... what is the thickness of the trackball mounting kit?  Is it the same 1/16" as it is for the mounting plate?

Navigation

[0] Message Index

[#] Next page

Go to full version