Main > Main Forum
how to tell which side of LED is ground?
leapinlew:
buy 2 -
try it both ways. ;)
loadman:
--- Quote from: leapinlew on April 02, 2007, 06:59:17 pm ---buy 2 -
try it both ways. ;)
--- End quote ---
...LED not Girls ;D
blueboy:
LOL....
Will try both ways..
I know nothing about correct wattage, i noticed these say resistor on board..
I have a total of 19 of them and one LED wiz powered by USB...anyone think it will blow the lights?
Thanks,
Blue
RandyT:
I'm confused. The stock buttons associated with the part number you provided are used with 14v light bulbs.
If you have purchased the LED "blade" lamp replacements, these have resistors built-in for the voltage specified by the part you purchased. If you got the 6v version, it will light at 5v, but won't be as bright.
It shouldn't be a problem if you hook them up backwards. It won't burn them out or anything, they just won't work until you get it right. Use one to figure out the correct orientation and then wire the rest the same way.
RandyT
blueboy:
Utt ohhh...
I did get the ones that are 14v...
It looks as though the LED wiz is for a total of 5v....
I'm assuming they will be dull as hell.....Any workaround?
I see the part about hooking the LEDwiz up to the powersupply but the directions are not more detailed than that.
Thanks,
Blue
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version