Main > Main Forum

Coin Door Question

(1/2) > >>

dndcollect:
I originally thought my coin door was not hooked up because when i put a quater in, it just comes out the return slot.

anyway, today i discovered that behind the door there is a little thing that looks like a straightened paper clip at the botton of the mechanism and when a pull it back it will give me a credit. so i guess it is hooked up?

so i am wondering how i can get this to work with a quater.

any ideas?

(also im a total newb)

johnm160:
If the quarter just comes back out the return chute the Coin Mech is probably set up for tokens and not quarters.  If you can get a part number off of it someone here might be able to identify it for you.

dndcollect:
it says WICO on it, i will keep looking for numbers. it is possible to set it to accept quaters?

Fozzy The Bear:

--- Quote from: dndcollect on March 12, 2007, 09:21:34 pm ---it says WICO on it, i will keep looking for numbers. it is possible to set it to accept quaters?

--- End quote ---

That's an impossible question to answer without knowing what coin mech it is that you have.... If you can't figure out what mech it is then post a picture of it.

Best Regards,
Julian (Fozzy The Bear)

dndcollect:
there was a sticker and it says the following:

WICO 15-8291-10

if that doesnt reveal the model then i can just take a pic, let me know, thanks.

Navigation

[0] Message Index

[#] Next page

Go to full version