Main > Main Forum

U360 problem

<< < (2/2)

johnvv:
It is my understanding that if there is no red LED, the PCB is dead.  Try it on another PC to be sure and/or plug it in as the only USB device on the bus.  If there is still no LED lit, you should probably contact Andy.

John VV

destructor:
1. Disconnect all 3 working U360s
2 .Now reconnect fourth not working U360 to one from USB port where 3 U360s were working
3. Check if now this not working U360 will work and post it here.

squirrellydw:

--- Quote from: destructor on January 31, 2007, 04:23:01 am ---1. Disconnect all 3 working U360s
2 .Now reconnect fourth not working U360 to one from USB port where 3 U360s were working
3. Check if now this not working U360 will work and post it here.

--- End quote ---

Still no luck.  Andy thinks the PCB is dead and I agree.  Not sure about the map issue but he is sending me two new boards.  Have to love Andy and Ultimarc, he really understands customer service.  I will not hesitate to order anything from  him.  He goes out of his way to help you and does it quickly.

Thanks Andy

rockin_rick:
I found that thread, not sure if it will help you, though.  Worth checking out...

http://www.mameworld.info/ubbthreads/showflat.php?Cat=&Number=91588

Rick

squirrellydw:

--- Quote from: rockin_rick on February 01, 2007, 12:38:21 am ---I found that thread, not sure if it will help you, though.  Worth checking out...

http://www.mameworld.info/ubbthreads/showflat.php?Cat=&Number=91588

Rick

--- End quote ---

I am using a laptop so I can't access the MB.   I will remember this when I order my new computer though

Thanks

Navigation

[0] Message Index

[*] Previous page

Go to full version