Main > Woodworking
Recommend router bits to get started
Druxar:
FOr someone just buying a router and no real idea what it can do or what use it will eventually bring (open mind), what would be some recommended router bits to have (besides the one that is the whole cause of a router purchase, a 1/16 slot).
There are various bit sets up to a few hundred dollars...to a new person is it more worth the money to just buy individual bits - are all the bits in those big sets similar and only useful for hard core wood workers?
What type of bits would make a good starter setup? I've heard mention of spiral, flush trimming, maybe something to do a rounded edge, but its' all a blur.
javeryh:
1. Slot cutter
2. Flush cutting bit
3. Pattern cutting bit
4. Dado cutter
5. Spiral
ScottS:
My advice is not to buy a big set of bits. They're normally complete crap and you'll never use half of them anyway. Buy the bits you need for the project at hand. Whiteside makes the best bits. I buy them at RouterBits.com.
If you have to buy a set, read Fine Woodworking's article on the "10 essential router bits". I think that Woodcraft has a page that lists these bits ten bits. Have to admit that I own a bunch of bits. The only ones I use are the slot cutter, rabbet set, and a few straight bits.
spiffykyle:
The bits I use most often are:
Straight (1/4" and 3/8")
Flush trim
Rabbettting bit with several bearings
spiral/mortising
Slot cutter
A pattern bit (essentially a V-groove) is normally used with a plunge router and templates to make signs or designs.
Chamfer and round over bits are for decorative edging (along with a ton of other edging bits) and only necessary if you need a pretty edge on a piece of wood (i.e. furniture)
Dovetail bits are only needed if you do dovetail joints (not for a newbie woodworker)
Additionally there are a ton of other sets for things like raised panels in doors and drawer locks for constructing drawer boxes.
I agree with not buying a big set since you probably won't use most of the bits.
For constructing a cab I would suggest the slot cutter for the T-molding, and a straight bit and flush trim bit for the recesses and cutouts. You shouldn't need anything else.
Make sure the bits you buy will fit in your router. Routers come with several different size collets (the part where you put the shaft of the bit), 1/4", 3/8" & 1/2". Make sure your bits have a shaft that will fit your router's collet.
Tahnok:
--- Quote from: spiffykyle on December 22, 2006, 11:22:54 pm ---A pattern bit (essentially a V-groove) is normally used with a plunge router and templates to make signs or designs.
--- End quote ---
I could have sworn that's actually just known as a v groove. A Pattern bit is kind of like a flush trim, but a little longer and with the bearings on top, example
Personally, I use both a pattern and flush trim quite often. Probably more than any other bit. I recommend both.