Main > Software Forum

Mame 1.08 / Mamewah 1.62b10 and happ USB trackball?

<< < (2/2)

u_rebelscum:

--- Quote from: Minwah on December 07, 2006, 11:49:25 am ---
--- Quote from: FrizzleFried on December 07, 2006, 09:47:33 am ---The problem is that your trackball is not your MOUSE DEVICE 0.   I assume you also have a mouse hooked up?   My cabinet is the same way.   My MOUSE is device 0 and my spinner is device 1.   I had to go in to the MAME config menu (TAB) and configure my "PADDLE" and my "DIAL" as device 1 (instead of 0).

Make sure you modify MAME.INI to read "MOUSE      1".

--- End quote ---

I am probably a bit out of date with stuff...so is my trackball_device etc advice wrong?  I think it is correct, but you then just have to be careful of any mouse-device-specific input mappings.

--- End quote ---

No you're correct.  Sounds like he had to remap his mouse device inside mame.

Minwah:

--- Quote from: u_rebelscum on December 07, 2006, 02:07:54 pm ---No you're correct.  Sounds like he had to remap his mouse device inside mame.

--- End quote ---

Thanks for confirming that :)

Navigation

[0] Message Index

[*] Previous page

Go to full version