Main > Main Forum
Ultrastik 360 in 3/4 panel
squirrellydw:
If I get an Ultrastik 360 and mount it in a 3/4 wood CP should I get the longer shafts? I am thinking I should. Also does it use the same mounting holes as a P360?
Thanks
fatfingers:
I ordered the longer shafts for my 3/4" panel and tried the short and the long -- the longer ones were way better in my opinion (oh, I also have 1/8" plexi over the panel). Sorry, but I don't know anything about P360s.
kowal:
--- Quote ---same mounting holes as a P360?
--- End quote ---
so this the same.
Donkey_Kong:
I mounted U 360's in 3/4" pine and went with the stock shafts but...I ROUTED out the bottom side as per Andy's suggestion. I'm liking the stick length this way and it saved me like $25 at least.
Note: To mount the stick this way I needed super short screws...For my final installation I used 6 per stick for extra hold.
squirrellydw:
How much longer are the long shafts?
Navigation
[0] Message Index
[#] Next page
Go to full version