Main > Main Forum

Taito Cocktail Plans *Sketch inside*

<< < (5/5)

johnm160:

--- Quote from: hbm*rais on October 31, 2006, 07:37:56 am ---Hi John,

Yes, I saw that picture after posting. I should have edited my post  :-[, sorry.

I have all the information I need for myself right now, but if you want to take some measurement of the CP's opening and the coin box opening, I can add it to the sketch for completeness sake. It may be useful for someone else.

Thanks again for everything!

--- End quote ---

Nothing to be sorry for.... ;D

I should be over there today I them while I am there.

 :cheers:

londonbabe:
Here's some plans I made when intending to scratch build a cabinet. (in the end I converted one instead)

It's not exact size of a Taito cab cos the measurements are altered to fit a 17 inch NEC FE700 monitor I was going to use.

(and I never tried making a scale model or anything, so some measurements might be wrong)

johnm160:

--- Quote from: hbm*rais on October 31, 2006, 07:37:56 am ---Hi John,

I have all the information I need for myself right now, but if you want to take some measurement of the CP's opening and the coin box opening, I can add it to the sketch for completeness sake. It may be useful for someone else.

Thanks again for everything!

--- End quote ---

Ok,

The cp opening is 14 1/4 x 5 5/8 and starts right at the very bottom, there is no material under the cp on the front panel it sits on the bottom board.


The Coin box opening is4 3/4 x 5"  inside and 6"x6" to the outside of opening that the box sits in. Also it is 9" deep.

Navigation

[0] Message Index

[*] Previous page

Go to full version