Main > Main Forum
Bolt Question - Sticky nuts problem
londonbabe:
Or try adding a couple of nuts on the end to lock against each other, giving you something to apply counter-force to when you undo the one at the top.
spystyle:
Using a dremmel with cutting disk -
Try cutting a slot into the top of the carriage bolt - this will turn it into a "flathead screw" instead of a carriage bolt. Then you can use a large flathead screwdriver to hold it while you back the nut off.
I use this method to remove phillips head wood screws that have become stripped. (Wood screws strip so easily, that's why I love drywall screws)
Cheers,
Craig
fatfingers:
--- Quote from: spystyle on October 16, 2006, 08:14:57 am ---Using a dremmel with cutting disk -
Try cutting a slot into the top of the carriage bolt - this will turn it into a "flathead screw" instead of a carriage bolt. Then you can use a large flathead screwdriver to hold it while you back the nut off.
I use this method to remove phillips head wood screws that have become stripped. (Wood screws strip so easily, that's why I love drywall screws)
Cheers,
Craig
--- End quote ---
Now if this isn't one of the smartest ideas I've ever heard of...
spystyle:
thx :)
severdhed:
--- Quote from: spystyle on October 16, 2006, 08:14:57 am ---Using a dremmel with cutting disk -
Try cutting a slot into the top of the carriage bolt - this will turn it into a "flathead screw" instead of a carriage bolt. Then you can use a large flathead screwdriver to hold it while you back the nut off.
I use this method to remove phillips head wood screws that have become stripped. (Wood screws strip so easily, that's why I love drywall screws)
Cheers,
Craig
--- End quote ---
another vote for this method. My marquee retainer was held in with those security torx screws that require the hollow torx bits, i just used a dremmel and made then slotted screws, works fine every time.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version