Main > Main Forum

Neat wiring job question

(1/5) > >>

fatfingers:

Hello.  I understand how to wire my control panel.  What I do not understand is how to do it neatly.  I'm even willing to give up on the neatly part, if someone would just give me an idea of what they use to "attach" the wires to the control panel so they are not hanging loose?  I have cable ties, but even if I use those, the tied wires still hang loose.

Thanks for any and all suggestions!

Vigo:
start by using cable clamps...Cheap and easy to find at almost any hardware store or even at a walmart.



just slip in the wires and screw down

gamecreature:
Or just staple the cable ties to your board.

spacies:

--- Quote from: Vigo on October 10, 2006, 03:27:43 pm ---start by using cable clamps...Cheap and easy to find at almost any hardware store or even at a walmart.



just slip in the wires and screw down

--- End quote ---

Those are a good solution. Here we call them 'P' clips.

ahofle:
I used 8 conductor wrapped cable and a staple gun to attach to the CP and it still looks messy.  But my wife says I am a slob, so....   :dunno

Navigation

[0] Message Index

[#] Next page

Go to full version