Main > Main Forum
SF II HF stuffed!!! :'(
Havok:
Those are scanlines. No problem found...
:laugh2:
*ShAgGy*:
no worries i'll check that out,
im only new when it comes to the PSU's or anything similar on these monkeys
so imma check it out,
does the problem yield fixable?
Timoe:
--- Quote from: *ShAgGy* on October 06, 2006, 08:49:22 pm ---no worries i'll check that out,
im only new when it comes to the PSU's or anything similar on these monkeys
so imma check it out,
does the problem yield fixable?
--- End quote ---
Yes, It might be something as simple as a chip that is not seated properly.
*ShAgGy*:
ok i have returned!
whipped out the ol multimeter and all things are fine
the thing i actually just noticed is,
no actual game sprites are displayed
as in selection screen and well as soon as the fight is suppose to appear
we get nothing ubt dead silence
played with a few chips and noticed the one next to number 19 was gettin hot
could be normal but again i dont know much in regards to PCB's
but i only fleetinging played with a few
any suggestions guys?
grantspain:
if the chip is too hot to touch then its more than likely dead but that usually only happens if you put the chip in back to front
is there any sign of spillage on the board anywhere?
if it were me i would reseat all the chips and boards first then read the +5volts on the edge connector(should be about 5.05 to 5.15)
just for information,today i had a daytona board showing a strange grid constantly.
i removed all the boards and washed them in a sink with washing up liquid and a paint brush then washed off with water and then used an air compressor to dry off,it worked a treat
Navigation
[0] Message Index
[*] Previous page
Go to full version