Main > Main Forum
Need help with T2 solenoid driver circuit!
1UP:
--- Quote ---I just started looking at this thread, and I think you guys are putting your back EMF diodes in the wrong place.
--- End quote ---
ErikRuud:
Here, I will post the link here as well.
Weeder Technologies
When I originally found the Weeder Site, he had an option to buy the boards as a kit. He seems to have dropped that option.
Elkor:
Well? did you get it working? don't leave us all in suspense! ;D
1UP:
Sorry for the wait, I've been sick!
Dav:
Good job. I don't know anything about the IPAC but generaly if you're too high on the current the resistance in your load is too low, it acts like a short circuit. So it can't be good for it. I wouldn't worry about the relay. I assume he was conservative in his maximum but you're way over. Driver boards usually have a small transitor first then the large transistor so they step up gradually in current draw.
I haven't done anything with the parallel port yet, I've been busy writing Z80 code and manufacturing circuit boards for my Ms Pacman project. I might see if I can find the source for it though. Maybe someone who's worked with parallel ports before will work on it. It may not be that difficult, but I haven't hooked up an led to my port yet so I can test.
Dave
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version