Main > Main Forum
Will this mod work?
Encryptor:
I bought a Discs of Tron cp with joystick because I thought the restrictor would be the same as a Tron joystick. They're not. Since Oscar isn't taking order I was wondering what I could do to make the one I have work. Here is my idea shown in the pics below. Any thoughts as to wether this will work as long as the screws don't interfere with the leaf switches. Any thought would be greatly appreciated. Thanks
Pics:
tron actuator - original tron joystick restrictor
dot current - original dot configuration
dot new - modified dot configuration
Encryptor
horseboy:
Seems like a good idea to me. It's probably at least worth a try.
NoOne=NBA=:
It will work fine, but you may run into some longevity issues if you don't swap out the top restrictor.
The top restrictor is the one that takes all the torque from the handle.
The bottom restrictor just guides the shaft at the bottom a bit.
Kremmit:
The hole on the Tron restrictor looks smaller than the hole on the D.O.T. restrictor. Anybody able to measure and verify?
If they don't match, I think the bottom restrictor from a Pac stick is the same as the Tron.
daywane:
The Ms pac is VERY close . bolts up just fine
I have 2 samples made at work that work very well also. To bad that maint. Man no longer works there :cry:
I have only used the old school Ms pac sticks! not the new ones, Never seen a new style ms pac J stick
Navigation
[0] Message Index
[#] Next page
Go to full version