Main > Main Forum
Suzo Inductive - how to connect?
Level42:
OK, I checked with Andy from Ultimarc and the current you can draw from the I-pac is simply what your mainboard can deliver. Should be around 500mA. That is more than enough since the Inductive draws 50mA max.
So you contrary what I said before you won't need a seperate power supply from the PC, you can simply connect it to the +5V and GND of the I-pac.
So what I will send you is the little white connector with the 6 wires on it, half a meter of length.
LarsDK:
--- Quote from: Level42 on October 03, 2006, 08:40:14 am ---OK, I checked with Andy from Ultimarc and the current you can draw from the I-pac is simply what your mainboard can deliver. Should be around 500mA. That is more than enough since the Inductive draws 50mA max.
So you contrary what I said before you won't need a seperate power supply from the PC, you can simply connect it to the +5V and GND of the I-pac.
So what I will send you is the little white connector with the 6 wires on it, half a meter of length.
--- End quote ---
Super. Thanks.
Level42:
Hey Lars,
It's ready as promised. I didn't use a 6 pin connector because we don't have them, instead I used one 2 pin and 1 4 pin connector. Doesn't make a difference really.
I included some pics. I take it you will know where to put each wire on the I-pac ?
I indcated the connectors a bit, but it was hard with the big marker I had laying around.
2 pin connector:
-=gnd
+= 5v
4 pin connector:
A=A
D=D
The rest will be OK automaticaly :D
Will send it tomorrow.
Level42:
Hi Lars,
Did you receive the connectors ?
LarsDK:
--- Quote from: Level42 on October 22, 2006, 02:37:10 pm ---Hi Lars,
Did you receive the connectors ?
--- End quote ---
Yes, it arrived yesterday.
Check your pm.
Anyone reading this with knowledge of I-PACs:
Can you tell me how I can draw 5v from the board?
Seems Andy told Level42 that you can do that. But I am unable to locate any 5v (or something similar) on the I-PAC.
Thanks,
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version