Main > Software Forum
AtomicFE support
headkaze:
--- Quote from: MYX on September 22, 2006, 09:27:12 am ---Because I can navigate inside AFE menus. Once MAME starts I hit the tab and have no reaction at all. Tab...nothing, esc...nothing. Joystick for ok...no go. So I am not sure where to go from here. I am using a GPWiz49 with 49 way joys.
I had to grab the keyboard and get out of there. Dunno what to do. :dunno
--- End quote ---
Tab not working in Mame? Check out this thread
Havok:
Good call - let us know if that doesn't work...
daywane:
--- Quote from: Havok on September 22, 2006, 08:28:20 am ---No problem!
Just trying to save you $20 - you need it to upgrade your internet service. You're still on dialup, aren't you?
Ouch!
I just got Fiber Optic service - love it!!!
--- End quote ---
stuck out here in the country... No other sevice available... 28k
Kills me... I put fiber optic around Phoenix Az and Bull head city NV
( to all you people out there... you are welcome.)
Here in KY the stupid Goverment still put up Telephone poles :banghead:
even said it would take 20 years to put lines under ground. ???
Yes it would if one person did it with a shovel :laugh2:
MYX:
--- Quote from: gonzobrian on September 22, 2006, 09:36:47 am ---Have you tried mame from a command prompt? Does it see the joys then?
--- End quote ---
I have always used MAME32. I am about an idiot when it comes to dos or the like. It does work from PowerMame32
MYX:
--- Quote from: headkaze on September 22, 2006, 10:12:33 am ---
--- Quote from: MYX on September 22, 2006, 09:27:12 am ---Because I can navigate inside AFE menus. Once MAME starts I hit the tab and have no reaction at all. Tab...nothing, esc...nothing. Joystick for ok...no go. So I am not sure where to go from here. I am using a GPWiz49 with 49 way joys.
I had to grab the keyboard and get out of there. Dunno what to do. :dunno
--- End quote ---
Ok just read this. This is a brand spankin new version of MAME. I have not modified any of it. with the keyboard I did tab and it did go into the config.
Tab not working in Mame? Check out this thread
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version