Main > Main Forum

Cutting diamond plate

<< < (2/3) > >>

_) (V) (-):
Your best bet would be to use a shear press.

Would cut through 8 ft of 1/4 thick material in about 1 second.


Perfect straight cuts too. Might be cheeper (than burning up blades) and quicker to find someone in a metal shop to do this for you.

Jetto Funk:
I was thinking of doing diamond plate for my cab but I dunno where to find it *Home depot and lowes and strikes so far*
How much did you pay for it?

sealslayer:
Only place I could find that sells it is a small hardware shop,none of the main chain stores over here seem to sell it, its not cheap though,

GoPodular.com:
You can get pieces suitable for smaller panels (like ours) at Menards.

dudebozo:
i remember seeing someone how had diamond plate as like a kickplate on their mame cabinet.  i asked him where he got it cause it seems like no where around where i live carries it.  this is the website that he gave me.  he said they were pretty dang good. 

http://www.cutsmetal.com/index.htm

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version