Main > Buy/Sell/Trade - non-retail
Replacement P360 actuators (better diagonals) $5 now! See kowal's posts, page 2.
hypernova:
--- Quote from: bleemus on September 13, 2006, 05:19:05 pm ---I would think that the outer diameter would need to be closer than the inner. Since the spring and the e-clip on the stick end up holding it pretty well in place on its own. Just as long as it is big enough, should be ok.
I mean, it would be good if they both were within .001, but i don't think that the inner diameter one would be the one to worry about... but I could be wrong.
The outer diameter has as 15 degree difference for a .5mm (or 0.019 inch). So that seems pretty important to me.
Maybe we can have kowal make a bunch and send them to someone in the US to distribute?
Also, on emachineshop, I noticed that even though the cost/unit is higher for aluminum over steel, the lathe cost ended up coming with a smaller quote for the aluminum; just something to check out.
--- End quote ---
In one of the reference threads, RNut stated that some of the sticks diameter are as large as .373 (I think) So the inner diameter would be a .375 with a .001 tolerance to accomodate all of them.
The OD, using RNut's recommendations, would be .541 +/- .019 as you found out. (I wasn't sure what to look for on the default tolerance.) So perhaps a tolerance of .003 would be acceptable to keep costs down.
This all may be moot as you suggested. If we can get a bunch from kowal, there's no preparation costs, so no wonder it's so low!
Kowal? How much would 30 cost? 50? Tell us a price, please.
(I'm trying to speak generically so it'll translate better for him.)
kowal:
--- Quote from: bleemus on September 13, 2006, 05:19:05 pm ---I mean, it would be good if they both were within .001, but i don't think that the inner diameter one would be the one to worry about... but I could be wrong.
The outer diameter has as 15 degree difference for a .5mm (or 0.019 inch). So that seems pretty important to me
--- End quote ---
every series P360 is different. Every model is different- even in the same series!
establishing common measure has not sense.
I when I did for friends (from Polish) actuator I let always and 2-3 kinds (14/13,7/13,5). And they chose the best.
--- Quote from: hypernova on September 13, 2006, 05:41:14 pm ---Kowal? How much would 30 cost? 50? Tell us a price, please.
--- End quote ---
I will know in several days, but this will be to cost little
ften:
I'm in for 2 if they are under 10 a piece.
-FTen
Luckydevil:
Just do the emachineshop route and have people start paying for them to get the ball rolling. People are going to start backing out if we wait to long.
Ten bucks each is completely resonable considering that you cant buy these anywhere.
bleemus:
--- Quote from: kowal on September 13, 2006, 05:47:59 pm ---I when I did for friends (from Polish) actuator I let always and 2-3 kinds (14/13,7/13,5). And they chose the best.
--- End quote ---
That might be nice, just get a pack of actuators that we could try for the sticks we happen to have.
Unless there is a way that we can find out the series and model number to be able to get a specific one made, that might be our only choice.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version