Main > Buy/Sell/Trade - non-retail
Replacement P360 actuators (better diagonals) $5 now! See kowal's posts, page 2.
quarterback:
--- Quote from: hypernova on September 07, 2006, 04:03:57 pm ---I'm currently trying to get quotes to have a custom sleeve (actuator) made for the Happ Perfect 360.
Threads of interest:
My thread
--- End quote ---
In that thread, Kowal says :
--- Quote from: kowal on September 04, 2006, 04:40:33 pm --- for 20 $?
very road.
it for this price was it been possible to have full modkit
--- End quote ---
It appears that Kowal is saying that $20 would get you a full modkit like the one in that picture.
So, is that a photo of the item that's being discussed in this thread? Are we talking about a "full modkit"? or are you just talking about an actuator?
bleemus:
Using emachineshop, I plugged the following made with aluminum:
length: 0.678" (17.23 mm.)
inside diameter: minimum 0.371" (9.43 mm.)
outside diameter: 13.5 mm = 0.5315" = 17/32" (also 14 mm = 0.5512")
It came out with 203.87 for 50 (~$4 each), 235.37 for 100 (~$2 each).
Just throwing it out there.
Luckydevil:
Two for me please! :cheers:
I'm a "definite."
RobotronNut:
--- Quote from: quarterback on September 10, 2006, 09:00:36 pm ---It appears that Kowal is saying that $20 would get you a full modkit like the one in that picture.
So, is that a photo of the item that's being discussed in this thread? Are we talking about a "full modkit"? or are you just talking about an actuator?
--- End quote ---
no, kowal is referring to a mod to the suzo inductive joystick, not the ultimarc 360. he's just pointing out that he can make a whole custom joystick shaft, including balltop, for the price that we're paying for a simple, tiny cylinder.
this appears to be a custom balltop shaft for the happ p360. i just found this page on kowal's website.
kowal - do you sell these balltop shafts for the happ perfect 360?
Havok:
--- Quote from: bleemus on September 10, 2006, 09:59:13 pm ---Using emachineshop, I plugged the following made with aluminum:
length: 0.678" (17.23 mm.)
inside diameter: minimum 0.371" (9.43 mm.)
outside diameter: 13.5 mm = 0.5315" = 17/32" (also 14 mm = 0.5512")
It came out with 203.87 for 50 (~$4 each), 235.37 for 100 (~$2 each).
Just throwing it out there.
--- End quote ---
If you could get the price down to about $5 each, I would be in for 2...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version