Main > Main Forum

UltraStik 360 not recognized?

<< < (2/2)

AndyWarne:
I can certainly help via email. One possibility is the motherboard having trouble with USB 2.0 devices.
Andy

destructor:
I have problem with U360 under Wi98SE. Win98 don't see my U360 (no unknown device and no ultrastik device in hardware manager).

What I did:
1. Enable PC
2. Plug U360 to PC using USB cable
3. Win98 say that found hew hardware and did something
4. I install Ultramap
5. Run Ultramap but no joysticks is found
6. I go to hardware manager but no unknown device and no ultrastik device there
7. I unplug, plug, reset PC, clear some devices in registry, still the same, no device.
Any help?

I don't have any problems under WinXP on the same PC (second HD).

I will try disable USB 2.0 for Win98.

EDIT
I disabled USB2.0, still the same, no U360.

destructor:
Heh, Interesting. U360 works fine one weeks ago on my WinXP. Next I plug U360 to the same PC using second hard disk with Win98SE and U360 doesn't work (as I write above).
Yesterday I install WinXP on old hard disk (previosus HD with WinXP I don't have now) and U360 doesn't work!!! Very strange. System say me that it's unknow USB device (one time system say me that it's UltraStik but otherwise it doesn't work). In device manager I see HID Human Interface Device but will yellow mark (problem) and it appear and disappera every 5 seconds (maybe 4 seconds), appear, disappear ....
I upgrade BIOS, USB drivers, UltraStik firmware (1.7 now) and still the same.

On my second PC (notebook) with the same WinXP and with USB1.1 only U360 works fine.

I tried all sugestions above. Nothing. Any more help? Maybe I should downgrade U360 firmaware?

EDIT
My motherboard is ASUS A7V600-X. I have 8 USB ports, I plug U360 in all ports.
I see in registry UltraStik and I see HID game controller in registry too. But in hardware manager it doesn't work.

EDIT
Probably I found solution. I change USB jumpers on my motherboard from 5V to 5VSB postion. U360 works fine now under WinXP and Win98SE.

Interesting thing that I have my previous HD and U360 doesn't work now on it with USB jumpers sets to 5V. Strange. With 5VSB all is OK.

Navigation

[0] Message Index

[*] Previous page

Go to full version