Main > Main Forum
wiring question
CheffoJeffo:
--- Quote from: squirrellydw on August 25, 2006, 03:06:53 pm ---Should I wire ALL my grounds together? As in going from one joystick to the next and all the buttons? I have six joysticks, 2 Reunions and 4 P360s and about 30 buttons. So I would go from the ground on the IPAC to the first switch, then to the next switch, etc and then back to the ground on the IPAC, right?
Thanks
--- End quote ---
That is how I do my panels (start at ground on the IPac, daisychaining the switch grounds and ending at the ground on the IPac), except for my 3-sided cocktail, where I did this for each panel individually.
Cheers.
squirrellydw:
--- Quote from: CheffoJeffo on August 28, 2006, 09:52:31 am ---
--- Quote from: squirrellydw on August 25, 2006, 03:06:53 pm ---Should I wire ALL my grounds together? As in going from one joystick to the next and all the buttons? I have six joysticks, 2 Reunions and 4 P360s and about 30 buttons. So I would go from the ground on the IPAC to the first switch, then to the next switch, etc and then back to the ground on the IPAC, right?
Thanks
--- End quote ---
That is how I do my panels (start at ground on the IPac, daisychaining the switch grounds and ending at the ground on the IPac), except for my 3-sided cocktail, where I did this for each panel individually.
Cheers.
--- End quote ---
So on your cocktail, do you have a total of 6 wire going to the ground on the IPAC or did you use a euro connector and have all the grounds going to that and then 1 wire going to the IPAC?
CheffoJeffo:
--- Quote from: squirrellydw on August 28, 2006, 09:59:21 am ---So on your cocktail, do you have a total of 6 wire going to the ground on the IPAC or did you use a euro connector and have all the grounds going to that and then 1 wire going to the IPAC?
--- End quote ---
Well, it was my first cabinet and the wiring is a bit of a disaster, so not the best example, BUT ... I actually ran the four (I forgot about the coin door and start buttons which are on the front of my cocktail, sonot wired with the CPs) "left side" grounds to a connector, then to one of the grounds on the IPac. Same thing with the "right side".
Did that make sense ?
Cheers.
squirrellydw:
I think I understand......I think I am going to wire each CP separately and use a euro connector to attach the ground and run one wire from that to the IPAC.
Navigation
[0] Message Index
[*] Previous page
Go to full version