Main > Main Forum

drilling/cutting holes in plexi?

(1/5) > >>

squire:
i going to start cutting the holes out in my CP plexi overlay,
if you dont mind what do you guys suggest to cut the plexi holes out with?
so i dont get that nasty chiping etc..

thanks so much
squire

shardian:
You can sandwich it between 2 pieces of wood...

NightGod:
Flush trim bit and a router.

shardian:

--- Quote from: NightGod on August 18, 2006, 03:11:43 pm ---Flush trim bit and a router.

--- End quote ---
Not applicable to button holes...

fatfingers:

--- Quote from: shardian on August 18, 2006, 03:20:32 pm ---
--- Quote from: NightGod on August 18, 2006, 03:11:43 pm ---Flush trim bit and a router.

--- End quote ---
Not applicable to button holes...

--- End quote ---

And why not?  I was thinking for my button holes I would drill (?) a smaller hole to fit the bit and then flush trim it from there?!?!?

Navigation

[0] Message Index

[#] Next page

Go to full version