Main > Main Forum

After a special type of T-Mold??

(1/1)

lettuce:
Does anybody know of a type of T-Mold that has lips at the top and bottom, so it would clamp plexi glass to a CP base?? I have a 1/2" MDF CP base and a sheet of plexi-glass covering it, and would like to clamp these together. As i think that the 1/2" MDF would be too narrow to route for normal T-mold??

NightGod:
1) there is 1/2" T-molding
2) T-molding with lip

lettuce:
The t-mold with lip is 13/16''  that would be to wide for 1/2" plus plexi-glass would it not?

Stingray:

--- Quote from: lettuce on August 05, 2006, 10:11:02 am ---The t-mold with lip is 13/16''  that would be to wide for 1/2" plus plexi-glass would it not?

--- End quote ---

Plexi comes in more than one thickness y'know. ;D

-S

Fozzy The Bear:

--- Quote from: lettuce on August 05, 2006, 10:11:02 am ---The t-mold with lip is 13/16''  that would be to wide for 1/2" plus plexi-glass would it not?

--- End quote ---

Yes but as has been said it depends how heavy your plexi is....  Plus you could always add a shim of plywood to the bottom of your 1/2" MDF around the outside edge, where you are putting the T-molding.

Best Regards,
Julian (Fozzy The Bear)

Navigation

[0] Message Index

Go to full version