Main > Woodworking

Table top design in metric

(1/3) > >>

geduk:
Hi all

This is my first post sorry if its in the wrong place bit it seems the best forum

Iv spent about two weeks trying to find a good table top design with a pref for metric measurements

an idiot prof one would be good for my first attempt can any one point me in the best direction

thanks

Ged

shardian:
you can always convert english to metric...

geduk:
lol

metric is english! and has been since 1971 30 plus years ago

its only the usa thats still stuck in the dark ages well pre 1970's any how :)

yes your are quite correct I can just do the convertion and that is my back up plan

kind of thought that some one out side the usa would have produced so plans it seems that this is more an american thing then I first thought

DrewKaree:

--- Quote from: geduk on July 28, 2006, 08:03:05 am ---
Iv spent about two weeks trying to find a good table top design with a pref for metric measurements

an idiot prof one would be good for my first attempt can any one point me in the best direction


--- End quote ---

Check all the table top cabinets in the Project Announcement section.  Some have plans or measurements, some don't.  You might see something in there that you like and you can PM the author to see if they could give you measurements.

Also, there is no such thing as an idiot proof design to a determined idiot ;D

londonbabe:

--- Quote from: geduk on July 28, 2006, 06:20:52 pm ---lol

metric is english! and has been since 1971 30 plus years ago

its only the usa thats still stuck in the dark ages well pre 1970's any how :)
--- End quote ---

No it's not. It's bloody French, it's meaningless, it's wrong, and it's crap. As a Briton you should be damn well ashamed of yourelf!

Newer <> better, and French certainly <> better.
:soapbox:

Navigation

[0] Message Index

[#] Next page