Main > Software Forum
freedo
unclet:
Yes I do ... and the spray paint seems to be spraying at a normal speed.
My freedo's CONFIG menu settings are as follows:
CEL
Clipping and Threaded options are selected
DSP
LLE option is selected
VDL
Extrapolation option is selected
Note: I did not need this setting when I was connected to a computer monitor, but when I transfered everything to my arcade cabinet (which interfaces to a TV) then I found the display did not work properly. Anyway, once I set this option then it displayed fine.
I made sure to load the "fz10_rom.bin" bios file one time after installing freedo.... which I am assuming you already did, then I simply start the program by calling the following:
FreeDoWrapper "C:\myGamePath\myGame.iso"
PS: Keep in mind that jcrouse's freeDoWrapper was written against the "freedoWIPv1.7" build of the emulator. I would assume you are using this version.
vulcanfk:
Just to put an end to this thread in case someone else comes across it...
it seems a 1.6GHz processor with 512MB RAM is insufficient for freedo to run games at 100% emulation speed.
Navigation
[0] Message Index
[*] Previous page
Go to full version