Main > Main Forum
Proper grounding
MYX:
Randy rocks.
That's all I can say.
coasternuts:
Yes Randy rocks! It turns out that if you use an Ultimarc Trackball with the Opti-Wiz then you need to place a 1K ohm resistor between the +5 and the data lines.
Just thought I would reply in case others end up with the same issue.
Thanks Randy!
lettuce:
So i take it all the grounds/COM for buttons and joystick on the CP go to the ground terminal on a I-PAC too?? If So what else can be grounded to this terminal??
Navigation
[0] Message Index
[*] Previous page
Go to full version