Main > Main Forum

best way to cut t-molding...?

(1/2) > >>

fixedpigs:
what is the best way to get a straight cut on the end of t-molding...?

                                                                                     thanks...!

Circo:
I just used a utility knife, had no problems whatsoever.

javeryh:
I used a utility knife too and it came out fine (not 100% perfect but close enough).  There is a thread around here somewhere where someone used a pipe cutter to get the perfect cut...

leapinlew:
I used scissors.

somunny:
I have one of those cutters that places like Home Depot use to cut rubber/plastic tubing.  Perfect cut every time.

Steve

Navigation

[0] Message Index

[#] Next page

Go to full version