Main > Main Forum
Lighted Button Kits .. $2.09 each ? Anyone use these ?
got_mame:
--- Quote from: butter5784 on July 13, 2006, 09:15:49 pm ---I was looking around and found these. They are considerably cheaper than others I've seen and they don't look bad. Does anyone have these ? Are they worth it ? http://www.dreamarcades.com/partsbuttons/index.shtml
--- End quote ---
Here are some pics of my Centipede mame control panel (links below), I am using 3 of these buttons. I'm running them off of the computers 5 volts along with the volcano buttons, and the trackball LED is run off of the computers 12 volts. Not sure why I did it that way, I think at one point I had a reason, anyways, you just need to make sure you use the appropriate resistor value with the LEDs. ...And yes, concave would have been better, but at the time it seemed like a good idea. By the way, where can I get concave translucent LED microswitch buttons in red, green, and blue?
http://pg.photos.yahoo.com/ph/webmail999/detail?.dir=4881&.dnm=8bc7re2.jpg&.src=ph
http://pg.photos.yahoo.com/ph/webmail999/detail?.dir=4881&.dnm=d330re2.jpg&.src=ph
Navigation
[0] Message Index
[*] Previous page
Go to full version