Main > Software Forum
Can anyone help? Apparently I'm an idiot
RTSDaddy2:
Havok:
Found my problem.
We'd recently done some work on the cabinet, mainly adding the marquee. In order to make room to get in and tighten everything up, I had to remove the Control Panel, which meant all the wires had to be removed.
When I rehooked everything, I found a wire I thought was my USB cable from the IPAC and hooked it back in. Little did I realize that I had actually hooked up an old USB joystick instead, AS WELL AS the IPAC. The USB Joystick was buried under a couple of paint bottles, and they apparently were pressing down on the stick just enough to cause it to move - either that or GameEx didn't know what to do with the two joysticks plugged in to different USB ports!
At any rate, all is right with the world again and I can proceed with fixing up my front end. Thanks for the tip - I might have never thought to check those connections if you hadn't mentioned a stray signal! :)
Havok:
--- Quote from: RTSDaddy2 on June 22, 2006, 08:24:54 pm --- I had actually hooked up an old USB joystick instead, AS WELL AS the IPAC.
--- End quote ---
I was just going to suggest you check for that joystick!
;D
Glad you got it working!
Navigation
[0] Message Index
[*] Previous page
Go to full version