Main > Main Forum
Solderless crimp connections for microswitches
SirPeale:
--- Quote from: JonnyBoy on June 04, 2006, 08:23:33 pm ---The tool will work fine for crimping, but it's awful for stripping. If it's just a few buttons it'll do but it really is worth it to get something else to strip wires.
--- End quote ---
One of the automatic wire strippers works well. However, I've never had an issue stripping with my crimpers. You insert wire, squeeze, release *slightly*, turn, and pull.
DaveJ-UK:
Thanks for the replies. Yes I am in the UK :)
I can't find anything in the UK by the same names that have been mentioned but these are what I've ordered:
Crimp Terminal, Female Push On Receptacle 6.3mm (PK 10)
Crimp Terminal Cover, Female, FASTON Clear (Pack of 10)
I'm pretty sure that will do the job.
I know that tool isn't great for stripping. I've actually got several sets including some automatic strippers but I always seem to misplace them and end up using the next best ::)
Orclord:
I wish I had read your first post in greater depth....
If you only wanted 10 I could have sent them to you by post FOC of course..
And I would not have bothered with the insulation, I only use that type on 240v connections.
Navigation
[0] Message Index
[*] Previous page
Go to full version