Main > Main Forum
Thread pitch for volcano buttons?
(1/1)
Dervacumen:
I don't have any so I can't measure the threads. I think I located some used switches that are similar to or identical to these but at a better price. Before I buy them I want to check to see if the threads are the same.
Thanks.
rdagger:
I have no way to measure the pitch but the diameter of the thread is 11.75 mm (.4625"). The nuts that come with the switches requre a 5/8" wrench. The lens has a diameter of 8.75 mm (.3445"). Hope that helps.
I recently picked up some used switches at a surplus store that I was able to convert. There's more info on my site.
leapinlew:
--- Quote from: rdagger on May 23, 2006, 12:19:36 pm ---I have no way to measure the pitch but the diameter of the thread is 11.75 mm (.4625"). The nuts that come with the switches requre a 5/8" wrench. The lens has a diameter of 8.75 mm (.3445"). Hope that helps.
I recently picked up some used switches at a surplus store that I was able to convert. There's more info on my site.
--- End quote ---
Damn! Thats a pretty impressive setup... Nice site!
Dervacumen:
rdagger, that info is what I needed. Turns out that the lens diameter is too small for what we need.
Thanks for the info!
Damn it. Back to square one.
Navigation
[0] Message Index
Go to full version