Main > Main Forum

Happs 3" trackball mounting

<< < (2/2)

Dustin Mustangs:
You must learn to search young grasshopper, this type of stuff gets asked all the time around here.

http://www.happcontrols.com/trackballs/55110100m.htm

Good luck on your project!

 ;)

ahofle:

--- Quote from: Hizzout on May 19, 2006, 12:22:37 pm ---Alrighty, thanks guys.  Are there pictures anywhere that show how to mount everything?  My confusion right now is the shape of the hole to cut to mount the trackball.

Thanks again

--- End quote ---

Using the mounting plate, the shape of the hole that the trackball goes through doesn't have to be pretty at all.  As long you make it sufficiently smaller than the plate and of course large enough that the trackball fits through, you can cut it any shape you want. 

miles2912:
Here is my CP with the TB hole in the middle and routed out to flush mount the TB plate.  I did not use plexi to overlay the CP.

D-

Navigation

[0] Message Index

[*] Previous page

Go to full version