Main > Software Forum

Zombie Raid!

(1/2) > >>

Hudson187:
Hi all! I just finally got around to installing my LCD topgun (i used the new ems driver and software; it works great!) and im having some trouble with zombie raid. I cant seem to get the game to save the in-game cailbration. Once I get it calibrated and play, it works great until I exit the game and go back into it, then the default calibration kicks back. I think im not saving the nvram correctly, but cant seem to figure out how to save it. Can anyone help? Thanks in advance!!!

Pi:
NVRAM is saved automatically. Be sure that the following requirements are met:
* You have your nvram_directory in mame.ini pointing to a folder called "nvram".
* Such folder "nvram" exists, and it's not write protected.
* If you have any file called zombraid.nv, delete it before trying again, as well as cfg/zombraid.cfg if it exist.

It's not a requirement that the folder is called "nvram", but if you change it, be sure to change the mame.ini setting.

Hudson187:
I figured it had something to do with nvram, so I did check the dir already. Its set correctly and I have other nv files for other games. Its not saving one for zombieraid!

Hudson187:
I checked again. The nvram folder was not write protected. Ive been trying for the past 20 minutes and it still wont save any nv ram file. Any other ideas?

Pi:
Actually I'm out of ideas, so unless it's a MAME bug, I'm blank. I don't even have the game to test it.

Navigation

[0] Message Index

[#] Next page

Go to full version