Main > Main Forum
Any suggestions for joystick dust washer material?
Luckydevil:
I just added wico balltops to my P360's and the holes on the dust washers are now too big.
Any suggestions as to what I should use to cut out a new pair of these? I know of course they are plastic, but I was hoping someone knew where I could get something in similar thickness and texture to cut these out of.
Xam:
Gahhhhh! I just recently threw away something you could have used! I had a used door panel...I used the plastic from the pocket on the door to make a face plate for my car stereo. I will see if we have any more door panels that have cleared and I can have.
Xam
19rjs99:
Use Plexi or Lexan. Cut it with a hole saw. and sand it smooth on the edges. Paint it with Krylon Fusion and your all set. You can make any size you need.
Bob
kowal:
I used packagings on CD. External black side has identical texture.
http://www.kupsprzedaj.pl/view-picture.asp?FileName=original/2/7/3/1730638017-PUDNONCDSL101.jpg
Timoe:
PM sent. I have some for you.
Navigation
[0] Message Index
[#] Next page
Go to full version