Main > Project Announcements
Fuzzy Wuzzy Was a Bear - Done for now
Dervacumen:
The CP, admin panel and a little extra artwork all done. Also finished the bezel.
Lots of detailed pics coming soon.
Dervacumen:
The Wiring Job. This is a mightly small CP for all the controls I have in there. It's removable via a DB25 cable. The trackball and Vortex spinner will attach via USB cables. I had to add the wooden block to lower the point at which the cable extend from the CP because of the construction of the original cabinet.
Dervacumen:
The first bit of my overlay has been applied. The t-molding is not permanent yet, I just stuck it on there quickly to see how the color looked.
I'll be installing the coin door lock soon.
The i-pac is installed and wired up to the other end of a DB25 cable so I can take off the CP.
The admin buttons are also wired in.
Next step is installing the computer, configuring the ipac and making sure it works.
I've also got most of my rely built for one button on-off action. I have not yet tested it.
Dervacumen:
--- Quote from: theCoder on May 23, 2006, 02:31:10 am ---Have you decided how you are going to mount the monitor?
--- End quote ---
Here are some more pics of how I kept this monitor on the shelf without moving around a lot. You can see the rail that I attached to the top of the monitor case. It has screws that stick up. I used some strapping that was lying around to attach those screws to a piece of wood in the cabinet. In addition, I took some more of the strapping, shaped it to fit around the outside of the monitor case, and bolted it down to the shelf.
My monitor does not move.
I hope you can tell from the pics how I did this. If not let me know.
theCoder:
Fur...I think you've got the first cab that includes vacuuming as part of the regular maintenance.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version