Main > Main Forum

Keywiz help needed

<< < (7/9) > >>

Tiger-Heli:

--- Quote from: kiddk1 on May 11, 2006, 01:24:18 pm ---I connected the white wire to the #5 on the keywiz and dropped a quarter and viola a credit, my next question is how can i wire it so it will credit when I push the coin return?

--- End quote ---
Here's one way to do it: http://1uparcade.robandmitsue.com/projects-coinbuttons.html

kiddk1:
the coin return stick a little, can I use wd-40 on the metal parts inside to free it up?

Fozzy The Bear:

--- Quote from: kiddk1 on May 11, 2006, 01:54:51 pm ---the coin return stick a little, can I use wd-40 on the metal parts inside to free it up?

--- End quote ---
Not recommended.... The WD40 will make coins stick to the surfaces rather than slide through.  Use the air duster to clean them then use the silcone polish on them.  You can use very very small amounts of WD40 on the springs and bearings BUT VERY VERY SMALL AMOUNTS!!

Best Regards,
Julian (Fozzy The Bear)

kiddk1:
cool thanks, I was going to post again but I will try to get an answer here. I just got my happs trackball and cant figure out how to wire it to my pc, I did do about an hour worth of searching and reading and came across a mouse hack which mostly came up "page not found"  I dont want to hack this thing up and ruin it, is there a way to connect this otherwise.  thanks

Fozzy The Bear:

--- Quote from: kiddk1 on May 11, 2006, 06:22:59 pm ---cool thanks, I was going to post again but I will try to get an answer here. I just got my happs trackball and cant figure out how to wire it to my pc, I did do about an hour worth of searching and reading and came across a mouse hack which mostly came up "page not found"  I dont want to hack this thing up and ruin it, is there a way to connect this otherwise.  thanks

--- End quote ---

Yes... Go back to Groovy Game Gear and buy one of their OptiWiz interfaces.

Best Regards,
Julian (Fozzy The Bear)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version