Main > Main Forum
(staining)now in need of router help
ShinAce:
Now I have a new question, regarding putting a 45 degree mitre on the panels I've cut.
I don't have a router, but can borrow one easily. However, I imagine a table router is going to be the way to go. I've cut the panels, squared them up, and sanded the edges. I'm thinking there will be no way to get a perfectly straight mitre on all edges unless I use a table router. At least that way, once routed, all panels will have exactly the same dimensions.
Is this correct?
Fozzy The Bear:
Yes... you could table route the edges..... But an easier option if you have one, is to cut it using a table circular saw. Pretty much the same result really.
Best Regards,
Julian (Fozzy The Bear)
ShinAce:
Hmm, very true....
Navigation
[0] Message Index
[*] Previous page
Go to full version