Main > Main Forum
Router Diameter for the following???
lettuce:
If i want to mount the following sticks and spinner, under my 1/2 " MDF Contol Panel, what diameter do the holes need to be routed at, so the shafts fit and enough for normal joystick movement?
Happ Comeptetion stick
Happ 49 way
Groovygamegear turbo spinner??
Moby Ick:
I wouldn't route. Use a Forstner bit (my favorite) or a spade bit.
I find the 49 way works great with 1 1/4 inch, 1 1/8 will knock of the far corners if the joystick isn't centered perfectly. I assume the other Happ can just use a 1 1/8. The spinner need less then 1/2 inch.
mike
lettuce:
Whats a Forstner bit, by the way. Is 1 1/4 the same used for push buttons??
Moby Ick:
What is a forstner bit: http://www.wisegeek.com/what-is-a-forstner-bit.htm
Pushbuttons use a 1 1/8 hole
Mike
miles2912:
This is the set I bought.
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=39811
Usually a single bit will run you 25.
Don
Navigation
[0] Message Index
[#] Next page
Go to full version