Main > Main Forum
Using a metal hole saw on aluminum
quarterback:
--- Quote from: mccoy178 on April 20, 2006, 10:04:37 pm ---I just made a little tutorial on how I made my holes. They were a hair too small for the leaf switches.
--- End quote ---
Exactly! In your previous search you must not have found my "Battle Royale Thread" where the masses kept trying to convince me that my leafs were going to fit into 1-1/8" holes even though it was clear they were not.
For those who are interested, you can start with this post and read the back and forth.. I finally had to contact Knievel via a PM and beg him to post in my thread since people didn't seem to believe me that it takes a 1-3/16" hole for leaf buttons to be installed in a metal CP, not 1-1/8"
Navigation
[0] Message Index
[*] Previous page
Go to full version