Main > Main Forum
Return to Center Happs Shifter question
(1/1)
leapinlew:
I have this shifter for my driving cabinet -
http://www.happcontrols.com/driving/50008300.htm
The turbo button on the handle has a wire sticking out that is some sort of 2 prong molex connector. Does anyone know how I can connect this to an ipac? I assume cut the molex connector off and run the ground to one and the other wire connects it to the ipac as a button. I'm used to having 3 connectors a ground, NC, and NO plug.
Am I understand this right?
Flinkly:
a button usually only uses 2 of the three plugs. think of it as a pushbutton which you usually make NO. The turbo button is probably the same and hook up just like you said.
Navigation
[0] Message Index
Go to full version