Main > Main Forum

non t molding molding

(1/3) > >>

juggle50:
Do you guys know of any molding that doesn't have th "t" in it and is maybe backed with some adhesive?  I should have routed around my panel and it's too late now.  It's for a desktop controller and it would only be about 4 and half feet that I would need.

Thanks

PoDunkMoFo:
I don't think anything with adhesive is going to hold up very well.

You could glue strips of Formica to the edge and then use a flush trim bit on it.  Also they make an edging material that you iron on that might hold up better.

Dizzle:
I wound up buying t molding and cutting the spine off with an exacto knife.  Then I used a hot glue gun to install it.  Not the preferable way to do it, but it worked pretty well for me.

Kremmit:
Step one:  Choose the color of T-molding you want.
Step two:  Go buy some paint in that color.
Step three:  Paint the edges.

missioncontrol:

--- Quote from: Kremmit on April 13, 2006, 10:45:53 pm ---Step one:  Choose the color of T-molding you want.
Step two:  Go buy some paint in that color.
Step three:  Paint the edges.

--- End quote ---

that would look awfull... just leat it bare... or possibly get some L shaped corner molding

Navigation

[0] Message Index

[#] Next page

Go to full version