Main > Main Forum

Groovygamegear Spinner Question **SOLVED**

(1/1)

oldskoolcade:
Just got my spinner (yay Randy!)

Maybe I'm dumb (my wife seems to think so most times), but I can't figure out how to adjust the height of the shaft so I can make it fit my control panel.  On the site it says to loosen the set screw, but I don't know which that is or where.

Anybody with some info that could help a dumb guy out, would be appreciated!

Cheers!
Mike

Timoe:
here ya go!


you will need a small allen wrench to loosen this screw.  Then pull the shaft up to the height you need and retighten the set screw.  Be sure not to over tighten.

oldskoolcade:
Thanks dude!   The second I saw your post, I got an e-mail from Randy explaining the same thing  :D

As I said to him, I knew it was a simple solution...it's just that I'm a little slow today  :P


Cheers!
Mike

Navigation

[0] Message Index

Go to full version