Main > Main Forum
Need Critics/Exp Builders for Comment on CP
bigbluezuk:
Before I start drilling does anyone see anything wrong with this control panel layout? This is a Lucid CP. There will also be a spinner mounted below the two buttons in the middle..
Thanks in advance.
http://www.at2k.org/john/cpo.gif
Excretious:
Looks good, post a pic when your done. It's a good setup for Golden Tee
miles2912:
Spinner might get in the way of the TB. I might mount it off to a side, bring the buttons down, straighten em out and balance the spinner with a 4 way stick. Can you tell I am into franken (read Practical) panels. :)
Don
bigbluezuk:
does there really need to be an angle on each set of controls? Miles I noticed you went normal (perpendicular) with
yours, how is that working out so far? Also, I covet your dewalt set..
Thanks for the input.
miles2912:
Very comfortable fit so far. What I did is built a cardboard mock up with cut outs of the buttons and sticks. Tape em down and see what feels right to you. If the angles work for you, go for it. ... and for the record I love that dam tool set. :)
Navigation
[0] Message Index
[#] Next page
Go to full version