Main > Main Forum

need happ P360 measure.

(1/5) > >>

bossyman15:
right now my CP is cut out for ulrimarc t-mag and one of hole (center of hole) is just under 3 inches from one of holes for trackball mount.

see i might buy p360 sometime in the future when i have money

so that's why i need measure of p360 so if i want to change joystick in the future it will fit in tight space.

anybody?

KDOG:
I think all of the happs bases are the same. So if you can find  either a super or comp measurement you should be strait.

RichyRich:
It will not fit,but you could always drill the hole pattern in the base of the 360.

bossyman15:
well you could just give me the measure of the base and i will cut it out on paper and see if it will fit.

Quarters:
The p360 base is a standard 3'' by 3.5'' same as most joysticks. There are some exceptions.

The pattern from the happ ultimate will work fine.LINK

Navigation

[0] Message Index

[#] Next page

Go to full version