Main > Main Forum
New Product: Lightmite TB Trackball Lighting Module **They're Here...**
Tahnok:
They look great, but which trackballs do they work with? It seems like, even with the swivel, it would only work with a certain size trackball. Will it work well with an Ultimarc 2.25"?
juggle50:
Cool Whammoed,
What are the mcds, beam angle and rated ma's of the led's that you sell with the product. I think a kit is probably what I'd be interested in. Well done again.
whammoed:
--- Quote from: tahnok100 on March 18, 2006, 01:21:19 am ---They look great, but which trackballs do they work with? It seems like, even with the swivel, it would only work with a certain size trackball. Will it work well with an Ultimarc 2.25"?
--- End quote ---
Works with an Ultimarc 2 1/4" fine
Works with Happ 3" (shown in pic)
The Happ 2 1/4" I received did not have a hole drilled for lighting, so I drilled one. Of course it works because I drilled the hole in a place that would allow it to. ;)
Those are all I have on hand, so if anyone has a trackball they want me to verify, please post the distance from mounting hole to the center of the trackball and I will check. Of course on most trackballs you can always drill the proper mounting hole but I don't think it will be necessary.
Anyone with a 3" betson care to post a measurement...if they have a mounting hole pre drilled that is.
whammoed:
--- Quote from: juggle50 on March 18, 2006, 02:03:44 am ---Cool Whammoed,
What are the mcds, beam angle and rated ma's of the led's that you sell with the product. I think a kit is probably what I'd be interested in. Well done again.
--- End quote ---
Depends on the color a little, but in general they are 6000mcd, 25degree, 20ma. I have brighter green ones also, but at 6000 its a little overkill as it is.
Also note that I mount the leds slightly off the board so they can be adjusted and the beam spread out. I believe this will allow for even very narrow beam leds to be used.
Level42:
Curious how to mount it to the Suzo 5.72 cm. trackball (=Ultimarc).
And being Dutch: What will they cost ? :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version