Main > Software Forum
Need INI files
electricd:
Ok apparently I am not creating my INI files correctly using the Mame Resolution Tool. I have an AVGA 7000 series, D9200, and mame .103. Would anyone with the same setup care to send me thier zipped ini files with the correct resolutions? For some reason when I generate mine, they are incorrect. Thanks in advance!
Minwah:
If you don't mind me saying I think a better solution would be to try and figure out why yours are incorrect...
Are you saying the resolutions within the ini files are wrong?
electricd:
Apparently so. For example, the resolutions created for galaga is:512x448 and pacman is also 512x448. So it puts a little screen in the middle of my D9200. I haven't identified which ones are incorrect but I know that a lot of the vertical ones are. Is there a tutorial perhaps on how to properly use the Mame Resolution Tool. I feel like I did it correctly, but you know how that goes. Thanks.
Minwah:
In the supplied readme there is a short how-to, which should be OK for most systems. It does assume a horizontal monitor and a few other things, but it should be a good start.
electricd:
Well just downloaded the program again and did just as the readme says and each time it still generates 512X448 for galaga, pacman, mspacman, etc. I don't know what I am doing wrong, but I just can't get it to get the right resolutions! I know galaga should be 288X244, but for some reason the mame resolution tool never puts it there?? HELP!
Navigation
[0] Message Index
[#] Next page
Go to full version